Toyota Motor Engineering & Manufacturing Recall List

List of the Toyota Motor Engineering & Manufacturing recalls announced through NHTSA

Some of the listed recalls may apply to multiple models. All affected models can be found in the details of each recall below.

308 results found

Recent Recalls

27. 1. 2006

Toyota Motor Engineering & Manufacturing – REAR SEAT BELT ANCHORAGE/FMVSS-210

CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE ANCHOR BOLT FOR THE REAR, LEFT-HAND SIDE…

22. 12. 2005

Toyota Motor Engineering & Manufacturing – 20″ AFTERMARKET ALLOY WHEELS

CERTAIN TOYOTA TUNDRA AND SEQUOIA TRUCKS EQUIPPED WITH TOYOTA RACING DEVELOPMENT (TRD) 20" ALLOY WHEELS SOLD AND INSTALLED BY TOYOTA DEALERS AS AN AFTERMARKET ACCESSORY WHEEL. DUE TO A MANUFACTURING…

19. 12. 2005

Toyota Motor Engineering & Manufacturing – ACCELERATOR PEDAL

ON CERTAIN PASSENGER VEHICLES, THERE IS A POSSIBILITY THAT THE ACCELERATOR PEDAL MAY TEMPORARILY BECOME STUCK IN THE PARTIALLY DEPRESSED POSITION DUE TO INADEQUATE CLEARANCE BETWEEN THE ACCELERATOR PEDAL LINKAGE…

22. 11. 2005

Toyota Motor Engineering & Manufacturing – TIRE INFORMATION LABEL/FMVSS 110 (CAMRY)

CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS" THE VEHICLES' TIRE AND LOADING INFORMATION LABEL OR PLACARD…

18. 10. 2005

Toyota Motor Engineering & Manufacturing – GLASS WIND DEFLECTOR

ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A GLASS WIND DEFLECTOR, THE DEFLECTOR, IF IMPACTED BY A PROJECTILE, SUCH AS ROAD DEBRIS, WHILE DRIVING WITH THE WIND DEFLECTOR IN THE UPWARD-TILTED…

6. 9. 2005

Toyota Motor Engineering & Manufacturing – STEERING RELAY ROD

ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES, IF THE STEERING WHEEL IS REPEATEDLY TURNED UNDER CERTAIN CONDITIONS WHERE HIGH STEERING EFFORT AND POWER ASSIST ARE REQUIRED, FOR INSTANCE, WHEN…

20. 7. 2005

Toyota Motor Engineering & Manufacturing – INCORRECT PASSENGER AIR BAG STATUS /FMVSS 208

CERTAIN PICKUP TRUCKS EQUIPPED WITH AUTOMATIC TRANSMISSIONS AND OPTIONAL FABRIC FRONT CAPTAIN'S CHAIRS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, 'OCCUPANT CRASH PROTECTION.'…

20. 7. 2005

Toyota Motor Engineering & Manufacturing – PASSENGER SEAT BELT

ON CERTAIN MINI VANS, IN THE MIDDLE ROW SEATING POSITION, THE SHOULDER PORTION OF THE SEAT BELT MAY BIND IN THE BEZEL TRIM PIECE. THE AFFECTED SEAT BELT BEZEL IS…

28. 6. 2005

Toyota Motor Engineering & Manufacturing – AIR BAG WIRING HARNESS

ON CERTAIN REGULAR CAB PICKUP TRUCKS EQUIPPED WITH A BENCH SEAT, THE SEAT POSITION AND SEAT BELT BUCKLE SENSOR CONNECTOR PINS ARE INCORRECTLY POSITIONED DUE TO A WIRE HARNESS MANUFACTURING…

2. 6. 2005

Toyota Motor Engineering & Manufacturing – FMVSS 225/208 PASSENGER AIR BAG CUTOFF SWITCH

CERTAIN PICKUP TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, 'CHILD RESTRAINT ANCHORAGE SYSTEMS.' THESE VEHICLES HAVE A MANUAL AIR BAG ON-OFF SWITCH…