VEHICLE DESCRIPTION: MINI VANS. THESE VEHICLES WERE PRODUCED WITH POWER WINDOWS THAT CAN BE CLOSED AFTER THE IGNITION KEY IS TURNED TO THE "OFF" POSITION AND THE RIGHT FRONT (PASSENGER)…
VEHICLE DESCRIPTION: PASSENGER MINI VANS EQUIPPED WITH AUTOMOTIVE BATTERIES SUPPLIED BY GNB TECHNOLOGIES. THESE BATTERIES HAVE A DEFECTIVE NEGATIVE POST THAT CAN CAUSE ACID LEAKAGE AND RELATED CORROSION DAMAGE.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. ONE OF THREE STYROFOAM PADS LOCATED IN EACH REAR DOOR AS PART OF THE DESIGN FOR ENSURING COMPLIANCE WITH FMVSS NO. 214, "SIDE DOOR STRENGTH," WAS…
VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO,…
THE RELEASE BUTTON USED IN THE REAR SEAT BELT BUCKLES WERE NOT MADE ACCORDING TO SPECIFICATIONS. IN HOT WEATHER, THE PLASTIC WELDS SECURING THE RELEASE BUTTON TO THE SPRING CAN…
CERTAIN BUCKLE ASSEMBLIES WERE PRODUCED WITH A "BUCKLE BASE" THAT WAS IMPROPERLY HEAT TREATED. THIS CAN CAUSE THE "BUCKLE BASE" TO BE BRITTLE FAILING TO COMPLY TO FMVSS NO. 209,…
THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE,…
AN OUT-OF-SPECIFICATION CONDITION IN THE SEAT CABLE ROLLER PULLEY ASSEMBLY CAN ALLOW THE CABLE THAT CONNECTS THE SEAT ADJUST LEVER TO THE LATCH TO BE PINCHED IN THE ROLLER ASSEMBLY.
A HARNESS CONNECTOR PROTECTOR LOCATED NEAR THE SEAT BELT PRE-TENSIONER CAN IGNITE DUE TO THE PROXIMITY TO THE COMBUSTION GAS GENERATED BY THE PRE-TENSIONER WHEN THE DEVICE IS TRIGGERED.
