General Motors Recall List

general-motors-recall-list

List of the General Motors recalls announced through NHTSA

Some of the listed recalls may apply to multiple models. All affected models can be found in the details of each recall below.

908 results found

Recent Recalls

30. 10. 1996

General Motors – GM/FMVSS 301

General Motors – GM/FMVSS 301
DURING ASSEMBLY OF THE LEFT REAR QUARTER PANEL, SOME WELDS WERE MISSED. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 301, "FUEL SYSTEM INTEGRITY."
28. 10. 1996

General Motors – GM/AIR BAG

General Motors – GM/AIR BAG
DURING DEPLOYMENT OF THE PASSENGER AIR BAG, THE AIR BAG FABRIC CAN SNAG ON A REINFORCEMENT INSIDE THE INSTRUMENT PANEL, CAUSING THE EXPANDING AIR BAG TO LIFT THE INSTRUMENT PANEL…
8. 10. 1996

General Motors – GM/STEERING SHAFT

General Motors – GM/STEERING SHAFT
THE INTERMEDIATE STEERING SHAFT LOOSENS AT THE STEERING SHAFT TO STEERING GEAR COUPLING. WITH THIS LOOSENESS, THE YOKE PINCH BOLT CAN WEAR ON THE SPLINES OF THE SHAFT UNTIL THERE…
1. 10. 1996

General Motors – GM/FMVSS 301 – FUEL TANK

General Motors – GM/FMVSS 301 – FUEL TANK
VEHICLE DESCRIPTION: SCHOOL BUSES BUILT ON GM P3 CUTAWAY CHASSIS. THE SCHOOL BUS, WHEN TESTED IN ACCORDANCE WITH FMVSS NO. 301, EXCEEDED THE ALLOWABLE FUEL SPILLAGE AS SPECIFIED BY THE…
26. 9. 1996

General Motors – GM/WATER INTRUSION

General Motors – GM/WATER INTRUSION
WATER INTRUSION INTO THE KICK PANEL AREAS IN FRONT OF BOTH THE DRIVER AND PASSENGER DOORS CAN CAUSE A CORROSION PATH BETWEEN THE BATTERY FEED AND THE ELECTRICAL GROUND.
29. 8. 1996

General Motors – GM/VISUAL; WINDSHIELD

General Motors – GM/VISUAL; WINDSHIELD
THESE VEHICLES WERE BUILT WITH AN INCORRECT WIPER BLADE ASSEMBLY (17" LONG INSTEAD OF 22" LONG) ON THE DRIVER'S SIDE. THIS DOES NOT COMPLY WITH FMVSS NO. 104, "WINDSHIELD WIPING…
23. 8. 1996

General Motors – GM/INTERIOR; SEATS.

General Motors – GM/INTERIOR; SEATS.
THE FRONT PASSENGER SEATS HAVE LESS LOCK PAWL ENGAGEMENT ON THE INBOARD FORE/AFT ADJUSTER THAN SPECIFIED. THIS DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS."