THE PARK PAWL SHAFT WAS IMPROPERLY POSITIONED WHEN THE ROLL PIN THAT RETAINS IT WAS INSTALLED DURING TRANSMISSION ASSEMBLY. IF THE SHAFT WAS NOT PROPERLY POSITIONED, THE ROLL PIN MAY…
WHEN IN THE SECONDARY LATCHED POSITION, THE DRIVER DOOR LATCHES MAY OPEN WHEN SUBJECTED TO TRANSVERSE LOADS LESS THAN THAT SPECIFIED IN FMVSS NO. 206, "DOOR LOCKS AND DOOR RETENTION…
THE WIRE HARNESS FOR THE POWER LUMBAR FEATURE ON THE SEAT IS UNDERNEATH THE FRONT SEAT CUSHION SUPPORT WIRES. THE SUPPORT WIRES ON THE DRIVER SEAT CAN CONTACT AND DAMAGE…
THE RIVETS HOLDING THE REAR OUTBOARD BELT D-RINGS WERE NOT HEAT TREATED PROPERLY CAUSING THE HEADS OF THE RIVETS TO FRACTURE UNDER LOAD AND FAIL TO HOLD THE D-RINGS TO…
THE STUDS WHICH ATTACH THE BRAKE MASTER CYLINDER TO THE POWER BRAKE VACUUM BOOSTER ASSEMBLY CAN DEVELOP STRESS CORROSION CRACKING AFTER BEING OPERATED FOR AN EXTENDED PERIOD OF TIME IN…
VEHICLE DESCRIPTION: MULTI-PURPOSE PASSENGER VEHICLES. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CAMPAIGN…
A DEFECTIVE CONTROL MODULE IN THE "AUTOLAMP" SYSTEM CAN MALFUNCTION. IF THE "AUTOLAMP" SYSTEM IS BEING USED TO ACTIVATE THE EXTERIOR LIGHT (INCLUDING HEADLAMPS), THE HEADLAMPS COULD SHUT OFF WITHOUT…