Winnebago Industries Recall List

List of the Winnebago Industries recalls announced through NHTSA

Some of the listed recalls may apply to multiple models. All affected models can be found in the details of each recall below.

193 results found

Recent Recalls

26. 1. 1998

Winnebago Industries – WINNEBAGO/LP HOSE

VEHICLE DESCRIPTION: MOTOR HOMES. A LIQUID PROPANE (LP) HOSE WAS INSTALLED IN THE RANGE BURNER BOX. THE ELEVATED TEMPERATURE THE HOSE IS EXPOSED TO INSIDE THIS BOX CAN PREMATURELY AGE…

9. 4. 1997

Winnebago Industries – WINNEBAGO/SEAT BELT ANCHOR

A SPACER WAS OMITTED AT THE LOWER SEAT BELT ANCHOR POINT OF THE DRIVER AND FRONT PASSENGER SEAT.

3. 2. 1997

Winnebago Industries – WINNEBAGO/SPARE TIRE CARRIER

THE SPARE TIRE CARRIER HOIST COMPONENTS CAN BECOME LOOSE WHILE TRAVELING AND ALLOW THE SPARE TIRE TO MOVE FROM ITS STORED POSITION TO THE ROAD SURFACE.

27. 12. 1996

Winnebago Industries – WINNEBAGO/AUXILLIARY GENERATOR

THE "O" RINGS OF THE REGULATOR ASSEMBLY IN THE ONAN EMERALD AND MARQUIS BRAND GENERATOR SETS CAN WEAKEN AND BREAK WHEN EXPOSED TO HIGH AMBIENT TEMPERATURES.

27. 12. 1996

Winnebago Industries – WINNEBAGO/TAIL LIGHT

THE TAIL LIGHT USED ON THESE VEHICLES WAS NOT CERTIFIED FOR THE UNITED STATES.

5. 11. 1996

Winnebago Industries – WINNEBAGO/SEAT BELT RETRACTOR

THE SEAT BELT RETRACTOR LOCATED NEXT TO THE DRIVER AND PASSENGER SEATS WILL NOT ALLOW THE BELT TO BE EXTENDED SO THAT IT CAN BE USED.

25. 10. 1996

Winnebago Industries – WINNEBAGO/GENERATOR FUEL LINE

THE GENERATOR FUEL SUPPLY HOSE LOCATED ADJACENT TO THE GENERATOR WAS NOT ROUTED OR CLAMPED PROPERLY AND COULD COME IN CONTACT WITH THE ENGINE EXHAUST.

9. 10. 1996

Winnebago Industries – WINNEBAGO/SEAT BELT ASSEMBLY

THE SEAT BELT "D" RING SUPPORT BRACKET FOR THE TWO COMPANION SEATS (SEATS BEHIND THE DRIVER/FRONT PASSENGER SEATS) WAS INCORRECTLY INSTALLED.

2. 8. 1996

Winnebago Industries – WINNEBAGO/FUEL; LPG LINES; NON-METALLIC.

THE LIQUID PROPANE (LP) GAS SUPPLY HOSE LOCATED ADJACENT TO THE LP TANK CAN CONTACT THE TANK PLUMBING GUARD CAUSING THE HOSE TO WEAR THROUGH ALLOWING LP GAS TO BE…

1. 8. 1996

Winnebago Industries – WINNEBAGO/EQUIPMENT: CERTIFICATION LABEL

THE CERTIFICATION LABEL ON THESE VEHICLES CONTAIN INCORRECT TIRE PRESSURE DATA. THIS DOES NOT CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS…