ON CERTAIN MOTORCYCLES, EACH TIME THE IGNITION SWITCH IS TURNED OFF, THE ENGINE CONTROL MODULE (ECM) PRE-SETS THE POSITION OF THE IDLE SPEED CONTROL (ISC) VALVE FOR SUBSEQUENT ENGINE STARTING…
ON CERTAIN PASSENGER VEHICLES, THE FRONT SEAT BELT TONGUE WILL NOT LATCH INTO THE BUCKLE AND, IN RARE CASES, EVEN THE LOCKED TONGUE WILL POP OUT BY LOW STRETCHING FORCE.…
ON CERTAIN VEHICLES EQUIPPED WITH 5-SPEED MANUAL TRANSMISSIONS, DUE TO IMPROPER SHAPE OF THE CLIP, THE RETAINING CLIP THAT KEEPS THE GEAR SHIFT CABLE ATTACHED TO THE GEAR SHIFT LEVER…
CERTAIN VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING." AN INCORRECT PRIMER MAY HAVE BEEN USED WHEN INSTALLING THE WINDSHIELD.
ON CERTAIN MOTORCYCLES, THE FUEL HOSE THAT CONNECTS THE TWO METAL FUEL DELIVERY PIPES MOUNTED ON THE THROTTLE BODY MAY HAVE BEEN CLAMPED AT A LOCATION ON THE PIPES THAT…
ON CERTAIN MOTORCYCLES, STRESS AROUND THE RIGHT FRONT FUEL TANK MOUNTING POINT CAN CAUSE HAIRLINE FATIGUE CRACKS TO FORM. THIS CAN RESULT IN A FUEL LEAK.
ON CERTAIN CALIFORNIA-SPECIFICATION MODEL MOTORCYCLES, REPEATED STRESS FROM VIBRATION CAN CAUSE A CRACK TO FORM IN THE AREA WHERE THE LIQUID/VAPOR SEPARATOR BRACKET IS WELDED INSIDE THE FUEL TANK. THIS…
ON CERTAIN MOTORCYCLES, THE IGNITION SWITCH WIRING HARNESS MAY HAVE BEEN IMPROPERLY ROUTED AT THE TIME OF PRODUCTION. IF THE WIRING HARNESS IS NOT ROUTED PROPERLY, IT CAN RUB AGAINST…
ON CERTAIN PASSENGER VEHICLES, THE LEFT SIDE OF THE RETAINER REAR DRIVE SHAFT MAY CRACK AND THE GEARS MAY GET STUCK DUE TO OIL LEAKAGE BY THE RETAINER.
ON CERTAIN PASSENGER VEHICLES, THE POWER STEERING PUMP PULLEY MAY SEPARATE FROM THE POWER STEERING PUMP DUE TO INADEQUATE WALL THICKNESS OF THE PULLEY.
