ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR ENGINES, A SINGLE BANK TYPE EXHAUST CLAMP WAS INSTALLED ON THE TAIL PIPES INSTEAD OF A DOUBLE BAND TYPE CLAMP.
ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH A DETROIT ENGINE AND A LEECE NEVILLE ALTERNATOR. THE ELECTRICAL TERMINAL AT THE ALTERNATOR END OF THE CABLE THAT RUNS FROM THE STARTER…
CERTAIN HEAVY DUTY TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 104, "WINDSHIELD WIPING AND WASHING SYSTEMS." THE WINDSHIELD WASHER WIPER SWITCH MAY NOT…
ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH INTERNATIONAL CODE 16SCH (LOWER BUNK WEBBING RESTRAINT). FOUR BOLTS HOLD THE BUNK WEBBING RESTRAINT LATCH BRACKETS TO THE BUNK BASE. THESE BOLTS WERE…
ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH A CATERPILLAR ENGINE WITH A 4 DEGREE TILT, THE STARTER FIELD-STUD MAY CONTACT THE FRAME RAIL BECAUSE OF VARIATIONS IN THE AIR GAP…
CERTAIN SCHOOL BUSES AND HEAVY DUTY TRUCKS BUILT WITH HYDRAULIC BRAKES AND AN AIR POWERED PARKING BRAKE (BRAKE CODE 04GAS) FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE…
ON CERTAIN HEAVY DUTY TRUCKS, THE BOLTS AND LOCKING NUTS USED TO HOLD THE BRAKE SPIDERS OR BRAKE ANCHOR PLATES TIGHT TO THE AXLES WERE UNDER-TORQUED ON THE RIGHT SIDE…
ON CERTAIN HEAVY DUTY TRUCKS, THE JOINT BETWEEN THE LOWER PORTION OF THE STEERING COLUMN AND THE UPPER END OF THE INTERMEDIATE STEERING SHAFT MAY HAVE A MISSING OR LOOSE…
ON CERTAIN MEDIUM AND HEAVY DUTY TRUCKS BUILT WITH DRIVELINE PARKING BRAKE CODES 04GAR, THE PARKING BRAKE ASSEMBLY MAY NOT HOLD THE VEHICLE IN POSITION WHEN SET. FACTORS CONTRIBUTING TO…
ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH BENDIX TC-7 TRAILER CONTROL HAND-OPERATED VALVE WITH PUSH-TO-CONNECT FITTINGS. THE DELIVERY PORT IN THE VALVE BODY MAY BE PARTIALLY BLOCKED DUE TO A…
