VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW TIE ROD ENDS ON CERTAIN MERITOR AXLES. THE TIE ROD AND DRAG LINK BALL STUD ENDS CONTAIN BEARINGS THAT ARE BELOW THE…
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED…
VEHICLE DESCRIPTION: CERTAIN HEAVY DUTY TRUCKS FAIL TO COMPLY WITH REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE HEADLAMP ASSEMBLIES HAVE THE BULB IDENTIFICATION FOR THE…
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCK CHASSIS EQUIPPED WITH MACK 16,000 LB., 18,000 LB., OR 20,000 LB. HEAVY DUTY STEERING AXLES. THE INNER WHEEL BEARING CONE FOR THE STEERING…
VEHICLE DESCRIPTION: FRONT DISCHARGE, REAR ENGINE MIXERS. THE FAN DRIVE PULLEY THAT ATTACHES TO THE WATER PUMP CAN SHOW EXCESSIVE AXIAL RUNOUT CAUSING THE FAN AND PART OF THE FAN…
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH DESIGN LEVEL 1, ROCKWELL FF980 SERIES FRONT AXLE. THE FRONT AXLE HUB FLANGE CAN DEVELOP CRACKS DUE TO HIGH STRESS LEVELS.
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY VEHICLES EQUIPPED WITH STEERING AXLE HUBS BUILT BY WEBB WHEEL FOR USE ON TRUCKS AND TRACTORS, PART NUMBERS WEBB 1530, VOLVO 90402-0006, OR EATON…
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. DURING ASSEMBLY, INSUFFICIENT TORQUE OCCURRED OF THE DRAG LINK TO THE AXLE STEERING ARM CONNECTION. IF THE DRAG LINK TO AXLE STTERING ARM…
VEHICLE DESCRIPTION: FRONT DISCHARGE MIXER CHASSIS. THE ORIGINAL EQUIPMENT MITER BOXES HAVE NO PROTECTIVE BOOTS ON THE SHAFTS AND DIRT CAN ENTER THE SYSTEM CAUSING THE GEAR SHAFT BEARINGS TO…
