Kawasaki Motors Corp., U.S.A. Recall List

List of the Kawasaki Motors Corp., U.S.A. recalls announced through NHTSA

Some of the listed recalls may apply to multiple models. All affected models can be found in the details of each recall below.

93 results found

Recent Recalls

16. 10. 2007

Kawasaki Motors Corp., U.S.A. – MUFFLER MOUNTING BOLTS

ON CERTAIN MOTORCYCLES, INSUFFICIENT TIGHTENING OF THE MUFFLER MOUNTING BOLTS COULD ALLOW THE BOLTS TO LOOSEN.

11. 6. 2007

Kawasaki Motors Corp., U.S.A. – REAR SHOCK MOUNT WELD

ON CERTAIN MOTORCYCLES, THE TOP MOUNT FOR THE SINGLE REAR SHOCK IS SPOT WELDED IN POSITION DURING FRAME MANUFACTURE, THEN IS SUPPOSED TO BE COMPLETELY WELDED TO THE FRAME IN…

7. 6. 2007

Kawasaki Motors Corp., U.S.A. – SIDESTAND SPRING WELDING

ON CERTAIN MOTORCYCLES, THE SPRING RETAINING PIN ON THE FRAME MAY NOT HAVE BEEN COMPLETELY WELDED IN PLACE AND COULD FALL OUT, ALLOWING THE SIDESTAND TO DROP INTO THE "PARKING"…

17. 5. 2007

Kawasaki Motors Corp., U.S.A. – ENGINE CONTROL UNIT/STALLING

CERTAIN MOTORCYCLES MAY STALL UNDER DECELERATION DUE TO AN IMPROPER SETTING OF THE ENGINE CONTROL UNIT (ECU).

17. 5. 2007

Kawasaki Motors Corp., U.S.A. – FUEL TANK LEAKS

ON CERTAIN MOTORCYCLES, THE FUEL TANK IS MOUNTED TO THE CHASSIS BY MEANS OF TABS THAT ARE SPOT WELDED TO THE TANK, THEN BRAISED/WELDED AROUND A PORTION OF THEIR CIRCUMFERENCE.

3. 1. 2007

Kawasaki Motors Corp., U.S.A. – FUEL TANK

ON CERTAIN NINJA MOTORCYCLES, THE FUEL TANK MAY HAVE BEEN PUNCTURED OR WEAKENED BY A FAIRING MOUNTING SCREW OR MANUFACTURING OPERATION.

26. 5. 2006

Kawasaki Motors Corp., U.S.A. – VEHICLE DOWN SENSOR BOLT

ON CERTAIN MOTORCYCLES, THE BOLTS HOLDING THE VEHICLE DOWN SENSOR MAY COME LOOSE AND ALLOW THE SENSOR TO FALL OUT OF ITS MOUNTING BRACKET.

24. 4. 2006

Kawasaki Motors Corp., U.S.A. – STEERING DAMPER BOLT

ON CERTAIN MOTORCYCLES, THE BOLT THAT ATTACHES THE STEERING DAMPER BODY TO THE FRAME BRACKET MAY NOT HAVE BEEN TIGHTENED SUFFICIENTLY DURING VEHICLE ASSEMBLY.

10. 1. 2006

Kawasaki Motors Corp., U.S.A. – LOWER FORK TRIPLE CLAMP

ON CERTAIN MOTORCYCLES, THE PINCH BOLT HOLE ON THE LEFT SIDE OF THE LOWER FRONT FORK TRIPLE CLAMP WAS NOT THREADED TO THE FULL DESIGN DEPTH. THIS ALLOWED THE PINCH…

30. 7. 2004

Kawasaki Motors Corp., U.S.A. – KAWASAKI/FRONTBRAKE HOSE

ON CERTAIN MOTORCYCLES, THE FRONT BRAKE HOSE CAN BECOME TRAPPED BETWEEN THE FRONT FORK AND FENDER, WITH SUBSEQUENT MOTION OF THE FRONT SUSPENSION ABRADING THE BRAKE HOSE.