Dana Incorporated Recall List
List of the Dana Incorporated recalls announced through NHTSA
Some of the listed recalls may apply to multiple models. All affected models can be found in the details of each recall below.
9 results found
Recent Recalls
10. 6. 2024
Dana Incorporated (Dana) is recalling certain D-Series and E-Series Steer Axles, and replacement tie rod assemblies for Dana D-Series and E-Series Steer Axles. The tie rod assemblies in these steer…
10. 7. 2023
Dana Incorporated (Dana) is recalling certain Dana-Spicer Driveshafts, model number SPL100 DS/CS. The driveshafts can break under certain loading conditions.
24. 4. 2023
Dana Incorporated (Dana) is recalling certain Spicer Ultimate Dana 60 Bracketless Crate Axles sold for Jeep Wrangler vehicles. The axel suspension bracket may prevent sufficient lubrication from reaching the pinion…
11. 6. 2020
Dana Incorporated (Dana) is recalling certain Heavy Vehicle Output shafts, part number 131536, used in drive axles manufactured for commercial vehicles. The output shafts may not have been properly heat…
13. 2. 2019
Dana Incorporated, (Dana) is recalling certain Ultimate Dana 44 Front Axle. The pinion tail bearing may seize and prevent the axle from rotating.
28. 7. 2017
Dana, (Dana) is recalling certain Spicer D-Series and E-Series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
10. 2. 2015
Dana Driveshaft Manufacturing (Dana) is recalling certain commercial vehicle lightweight driveshafts, model SPL250, sizes 1610-2200 or 2220-2830, manufactured January 2, 2013, through June 30, 2013. In affected driveshafts, the welded…
29. 7. 2014
Dana Driveshaft Manufacturing (Dana) is recalling certain commercial vehicle lightweight driveshafts, model SPL250. In affected driveshafts, the welded bond of the driveshaft and the rear yoke may fail, leading to…
17. 2. 2010
DANA HOLDING CORPORATION HAS NOTIFIED NHTSA ABOUT A DEFECT IN CERTAIN TUBE YOKES, MANUFACTURED FROM HEAT CODE NOS. SD231/DF AND SD258/DV AND FORGED IN SPECIFIC MOLDS (CAVITY 1 AND 3),…
