CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, "PASSENGER CAR BRAKE SYSTEMS." THE CAP OF THE BRAKE FLUID RESERVOIR HAS BEEN…
ON CERTAIN MOTORCYCLES, THE FUEL PUMP WIRING SET HAS NOT BEEN MANUFACTURED ACCORDING TO SPECIFICATION. THE CONTACTS IN THE PLUG FOR THE FUEL PUMP CAN BREAK.
ON CERTAIN MOTORCYCLES, A LEFT-SIDE CHAIN TENSIONER HAS BEEN INCORRECTLY INSTALLED ON THE RIGHT SIDE. AS A RESULT, A HEX NUT, WHICH IS USED TO SECURE THE CHAIN TENSIONER, IS…
ON CERTAIN MOTORCYCLES, THE CLAMPING BLOCKS AND THE TOP FORK BRIDGE WERE NOT MANUFACTURED ACCORDING TO SPECIFICATIONS. CONSEQUENTLY, THE HANDLEBARS MIGHT NOT BE HELD SECURELY IN POSITION.
CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, 'OCCUPANT CRASH PROTECTION.' THE FRONT PASSENGER SEAT HAS A SENSING SYSTEM TO DETECT…
ON CERTAIN MOTORCYCLES, THE WELD BETWEEN THE SIDE STAND AND THE FRAME BOTTOM SECTION WAS NOT POSITIONED PROPERLY. THE LOAD-BEARING CAPABILITY OF THE SIDE STAND IS AFFECTED. AS A RESULT,…
ON CERTAIN MOTORCYCLES, FREQUENT SHORT TRIPS PARTICULARLY DURING COLD TEMPERATURES, CAN CAUSE WATER TO ACCUMULATE IN THE OIL TANK, AND WHEN THE ENGINE IS RUNNING, ESCAPING WATER VAPOR CAN CONDENSE…
ON CERTAIN MOTORCYCLES, THE TIRE INFLATION VALVE HOLE IN THE RIM OF THE CROSS-SPOKE WHEEL WHICH IS EQUIPPED WITH THE OPTIONAL TIRE PRESSURE MONITORING SYSTEM (TPM) WAS INCORRECTLY MANUFACTURED. A…
ON CERTAIN MOTORCYCLES, DURING ASSEMBLY, THE FINAL-DRIVE ASSEMBLY O-RING MAY NOT HAVE BEEN INSTALLED CORRECTLY. A LEAK MAY OCCUR AT THE LOCATION OF THIS O-RING WHICH IS NEAR THE REAR…
ON CERTAIN VEHICLES, ONE OF THE SUSPENSION CONTROL ARM AND SWIVEL BEARING CONNECTION BOLTS WAS NOT TIGHTENED CORRECTLY. THE BOLTED CONNECTION COULD LOOSEN.
