EQUIPMENT DESCRIPTION: MAY COAL DUMP BODIES MANUFACTURED BETWEEN MAY 1, 1998 AND JULY 15, 2000. THESE BODIES DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, “LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT,” FOR ONE OR MORE OF THE FOLLOWING REASONS: A) COAL BODIES EQUIPPED WITH NON-REFLECTIVE LAMP LENSES, BODY REAR AND BODY SIDE REFLECTIVE DEVICES MAY NOT HAVE BEEN INSTALLED; B) THE STOP/TURN/TAIL LAMPS ARE MOUNTED ON THE END OF THE TRUCK CHASSIS (ACCORDING TO THE STANDARD, THE FACE OF THOSE LAMPS SHOULD BE NO MORE THAN 12 INCHES FROM THE EXTREME REAR OF THE VEHICLE); C) THE THREE LAMP IDENTIFICATION LAMP CLUSTER IS MOUNTED ON THE END OF THE TRUCK CHASSIS (ACCORDING TO THE STANDARD, THE FACE OF THOSE LAMPS SHOULD BE NO MORE THAN 12 INCHES FROM THE EXTREME REAR OF THE VEHICLE;) D) ON CERTAIN COAL BODIES EQUIPPED WITH PERMANENT “BOARD(S) OVER GATE,” THE IDENTIFICATION LAMP CLUSTER IS MOUNTED ON THE END OF THE TRUCK CHASSIS (ACCORDING TO THE STANDARD, THE FACE OF THOSE LAMPS SHOULD BE NO MORE THAN 12 INCHES FROM THE EXTREME REAR OF THE VEHICLE); AND E) REAR CLEARANCE LAMPS, MOUNTED WITH THEIR CENTER LINES WITHIN 6 INCHES OF THE EXTREME OUTER SIDE OF THE BODY, WERE NOT INSTALLED ON COAL BODIES EQUIPPED WITH STOP/TURN/TAIL LAMPS MOUNTED AT THE REAR OF THE TRUCK CHASSIS.